Epson S020122 - Manual (Page 3)

EPSON
MSDS # S020122 Version 3.54 (USA)
Page 3 of 4 Release Date 04/2010
Appearance: Yellow Liquid
Odor: None
pH: 9 - 10
Boiling point: Approximately 212 deg. F / 100 deg. C
Freezing point: Less than 32 deg. F / 0 deg. C
Melting point: Less than 32 deg. F / 0 deg. C
Flash point: Greater than 230 deg. F / 110 deg. C (closed cup, ASTM D3278)
Autoflammability: None
Explosive properties: None
Oxidizing properties: None
Vapor density:
Greater than 1 (air = 1)
Relative density: 1.07 at 68 deg. F / 20 deg. C
Solubility in water: Complete
Solubility in fat:
No data available
Partition coefficient: No data available
Viscosity: Less than 5 mPa-s
10. Stability and Reactivity
Stability: Stable
Hazardous polymerization:
Will not occur
Hazardous decomposition products: None
Incompatible materials:
Oxidizers and explosives
11. Toxicology and Health Hazards
Routes Of Overexposure: Eye, skin, inhalation, and oral
Acute Health Hazards:
• Overexposure of eye surface to ink may be mildly irritating
• Overexposure of skin to ink contact may cause irritation and in some people swelling and redness
• Intentional inhalation overexposure to ink vapors may result in respiratory tract irritation
• Intentional or accidental oral ingestion may cause an upset stomach
Chronic Health Hazards: None known
Carcinogenicity: None Known
Toxicity Data: Oral LD50 Dermal LD50 Inhalant LC50 OSHA Regulated?
> 5000mg/kg(Rats) >2000mg/kg(Rats) Not Applicable Not Established
12. Ecological Information
No data available on the adverse effects of this material on the environment
13. Disposal Considerations
Used and unused cartridges are not a federal RCRA hazardous waste. Disposal should be in accordance with federal,
state, and local requirements.