Electrolux 58840R - Manual (Page 39)

The door stop may only be changed by a specialist. If necessary, please contact our
after-sales service or your specialist dealer.
WARNING!
Before changing the door stop, disconnect the mains plug.
1. Open loading door.
2. Unscrew hinge
A from the front of the
machine and take off the loading door.
3. Remove cover plates B and C. To do this,
insert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block D from
the snap-on fixture, take out and re-in-
sert on the other side having rotated the
block through 180°.
5. Unscrew hinge A from the loading door,
rotate through 180°, re-insert on the
opposite side and screw down.
6. Re-insert cover plates B and C on the opposite site having first rotated them
through 180°.
A C
C
D
A
B
Installation 39