Electrolux 58840R - Manual (Page 34)

Machine settings
Setting Implementation
BUZZER permanent off 1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS DROOGTEGRAAD and
RPM T/MIN buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off. You can use BUZZER
option to activate or deactivate sound but machine does
not memorize your selection.
Water hardness
Water contains, a variable quantity
of limestone and mineral salts of
which quantities vary according to
geographical locations thus vary-
ing its conductivity values.
Relevant variations of the
conductivity of the water compared
to those prefixed by the factory
could slightly influence the residual
humidity of the laundry at the end
of the cycle. Your dryer allows you
to regulate the sensitivity of the
drying sensor based on
conductivity values of the water.
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS DROOGTEGRAAD and
TIME TIJD PROGR. buttons and hold down for approx. 5
seconds. The current setting is on the display:
–
low conductivity <300 micro S/cm
– medium conductivity 300-600 micro S/cm
– high conductivity >600 micro S/cm
3. Press the START PAUSE START PAUZE button sequentially
until you set desired level.
4. To memorize setting press simultaneously the DRYNESS
DROOGTEGRAAD and TIME TIJD PROGR. buttons or turn
knob to OFF UIT position
Emptying water tank - warning
message permanent off
When using an external drain for
the condensed water.
1. Turn the programme selector to any programme.
2. Press simultaneously the RPM T/MIN and TIME TIJD
PROGR. buttons and hold down for approx. 5 seconds.
The current setting is on the display:
– warning icon and
- warning message is
off
– warning icon and - warning message is
switched on
By default the warning message is switched on and displayed
always at the end of the drying cycle or during the cycle if
the water container is full.
34 Machine settings