Electrolux WA GLE S7000 - Manual (Page 21)

Cancelling a programme
Turn the selector dial to O to cancel a programme which is running. Now you
can select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the Start/Pause button. If the «Door»
light goes off, the door can be opened.
If the «Door» light doesn’t go off and the door remains locked, this means that
the machine is already heating, that the water level is above the bottom edge of
the door. In this case the door can not be opened.
If you cannot open the door but you need to open it, you have to switch the
machine off by turning the selector dial to
O. After about some minutes the
door can be opened (pay attention to the water level and temperature!).
After closing the door, it is necessary to select the programme and the options
again and to press Start/Pause button.
At the end of the programme
The machine stops automatically, the Start/Pause light and the «Washing» light
go off and a flashing
0 will appear on the display. The buzzer sounds.
If the Rinse Hold option has been selected, the «Door» pilot light illuminates, a
flashing
0 will appear on the display, the Start/Pause light goes off and the door
remains locked to indicate that the water must be emptied out before opening
the door.
To empty out the water please read the steps on the Rinse Hold option
paragraph.
Turn the programme selector dial to « O» to switch the machine off.
Remove the laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the
door open to prevent the formation of mildew and unpleasant smells.
21 Use
132962330_EN.qxd 10/06/2008 14.03 Pagina 21