Assembling – Echo SRM-2305 User Manual

Page 13

SRM-2305

ASSEMBLING

Handle assembling bolt (8 mm)

Handle assembling
bracket (lower)

To engine

Washer

Install handle assembling bracket (upper) in handle
assembling bracket (lower) and fix handle by tightening
handle assembling bolt (8 mm) lightly.

Adjust inclination of handle to adequate position (easy to
operate) and tighten firmly handle assembling bolt (8 mm).

To eliminate loosening of throttle wire fix it to shaft tube
(2 places) and to right hand U-handle (1 place) with wire
fixing clips.

Handle assembling
bracket (upper)

Wire fixing clip

Shaft tube

Throttle wire

Nuts

CAUTION

After assembly, adjust the play of wire end on
carburettor side to 1 mm - 2 mm.

1 - 2 mm

Carburettor

Wire end

INSTALLATION OF BRACKET

Fit bracket to mounting portion of angle transmission and
fix the bracket by holding fitting plate pressed from beneath
and tightening 4 bolts (M5

25) lightly.

Get notches and convexes of fitting plate to face
corresponding convexes and concaves of bracket, and fix
bracket tightening 4 bolts (M5

25) securely.

Bracket

Bolt M5×25

Convex of fitting plate

Fitting plate

Notch of
fitting plate

There are two types of shields: namely one used exclusively
for Nylon line and another one used exclusively for steel
blade. When Nylon line is used, use the shield for Nylon
line. When steel blade is used, use the shield for steel
blade.

METHOD TO CHANGE SHIELD
(FOR STEEL BLADE)

Remove screw (M5

18) on the right side of the shield and

slide the shield to the left and remove it. Put shield of
another type into groove and slide it to the right until it stops
and be sure to fasten with the removed screw (M5

18).

When using Nylon line, use the shield for Nylon line
(see page 15). Fit cut off knife to the shield for Nylon line
using screw (5

12).

Bracket

Shield

Screw M5