Echo SRM-2305 User Manual
Page 11
11
SRM-2305
WARNING
DANGER
USE EXTREME CAUTION WHEN OPERATING
OVER BARE SPOTS AND GRAVEL, BECAUSE
THE LINE CAN THROW SMALL ROCK PARTICLES
AT HIGH SPEEDS. THE SHIELD ON THE UNIT
CANNOT STOP OBJECTS WHICH BOUNCE OR
RICOCHET OFF HARD SURFACES.
Do not trim near cars or pedestrians.
Always wear proper eye protection against thrown
objects. Objects can bounce up at you from the ground
under the shield, or ricochet off any nearby hard
surface.
Do not trim at high speed near roadways when there is
traffic, or in places where there are pedestrians. If you
must trim where people are in the zone of risk use a
much lower or reduced speed, by using a partial trigger
setting. Do not use full throttle.
Do not push the line into tough weeds, trees, or wire
fences. Pushing the line into chicken wire, chain link
fencing or thick brush can result in snapped-off line
ends being hurled back at the operator. The proper way
is to cut right up to a barrier, such as any of those
mentioned, but never run the line into or through the
obstruction. Do not cut closely to obstruction or barrier.
Line pushed into wire
fencing will snap off.
WARNING
DANGER
ALWAYS STOP THE ENGINE WHEN A CUTTING
ATTACHMENT JAM OCCURS. DO NOT ATTEMPT
TO REMOVE AN OBJECT CAUSING A JAM IF THE
ENGINE IS RUNNING. INJURY CAN OCCUR IF A
JAM IS REMOVED AND THE CUTTING
ATTACHMENT SUDDENLY STARTS.
WARNING
DANGER
• SERIOUS INJURY MAY RESULT FROM THE
IMPROPER USE OF CUTTING ATTACHMENT.
READ AND COMPLY WITH ALL SAFETY
INSTRUCTIONS LISTED IN THIS MANUAL.
• USE ONLY CUTTING ATTACHMENTS
RECOMMENDED BY KIORITZ CORPORATION.
WARNING
DANGER
USE ONLY NYLON LINE. DO NOT USE ANY TYPE
OF METAL BLADE.
WARNING
DANGER
EXCESSIVE NYLON LINE BEYOND CUT OFF
KNIFE COULD FLY OFF WHEN THE NYLON LINE
CUTTER STARTS ROTATING AFTER
ADJUSTMENT OF NYLON LINE LENGTH.
F-4/10
Avoid wire
Avoid nylon line contact with broken wire fencing. Pieces
of wire broken off by the trimmer can be hurled at high
speeds.
WARNING
DANGER
DO NOT TRIM IN ANY AREA WHERE THERE ARE
BROKEN STRANDS OF FENCING WIRE. REMOVE
THE BROKEN PIECES OF WIRE, OR GIVE THE
AREA WIDE BERTH. WEAR PROPER SAFETY
PROTECTION. DO NOT CUT WHERE YOU
CANNOT SEE WHAT THE CUTTING DEVICE IS
CUTTING.
USE CORRECT CUTTING ATTACHMENT