Euro-Pro V1930 - Manual (Page 11)

9
OPERATING INSTRUCTIONS
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
SWEEPER WILL
NOT OPERATE
1. Batteries discharged.
2. No power in electrical
outlet supplying charging
adapter.
3. Unit needs servicing.
4. Battery
misplaced.
5. Brush roll jammed.
1. Charge unit.
2. Check fuse or breaker.
Replace fuse/reset breaker.
3. Call Customer Service at
1 (800) 798-7398.
4. Ensure that the wire terminal
connectors are securely
attached.
5. Clear any obstruction from the
rotating brush. Turn unit off for
10 seconds, and then restart.
SWEEPER WILL
NOT PICK-UP 1. Dust container is full.
2. Unit needs recharging. 1. Empty dust container.
2. Charge
unit.
DUST ESCAPING
FROM SWEEPER
1. Dust container is full. 1. Empty dust container.
ROTATING BRUSH
WILL NOT PICK UP 1. Unit clogged.
2. Dust container is full.
1. Check for excessive material
on brush or in bottom of
sweeper. Remove obstruction
from brushes and/or sweeper.
2. Empty and clean dust
container.
SWEEPER WILL
NOT CHARGE
1. Electrical outlet not
working.
2. Charging Adapter not
working.
3. Batteries no longer
functioning.
4. Unit left in “On” position.
1. Check to ensure outlet is
working properly. (Easily
checked by plugging in
another appliance.)
2. Replace charging adapter.
3. See battery disposal.
4. Press switch to “Off”.
OPERATING INSTRUCTIONS
Care And Maintenance
To improve the performance and life of your unit, we recommend you do the
following:
1. Once a month clean the unit with a dry cloth, including the chamber which the dust
container fits into. Remove any hair, fiber or other materials that may have built up
in the chamber, and on the rotating brush.
2. Don’t use abrasive materials to clean the sweeper. DO NOT immerse the unit in
water.
3. DO NOT pick up liquids or use on wet floors.
4. DO NOT use on concrete, tar or similar rough surfaces.
5. Don’t pick up pieces of string or fabrics with the sweeper.
6. DO NOT clean tasseled or frayed carpets with the sweeper.
12
NOTA: La barredora inalámbrica viene con la batería descargada.
Necesita cargar la unidad por 20 horas antes de usarla por
primera vez. Use únicamente batería de reemplazo #
X1725QN.
* El dibujo puede no ser igual al producto real.
PARTES Y COMPONENTES
1. Botón de Liberación del Mango
2. Mango Superior
3. Pivote
4. Tubo de Extensión del Mango Inferior
5. Mango Inferior
6. Luz Indicadora de Carga
7. Llave de Encendido
8. Cargador: Use Unicamente KUANTECH
KA12D075015023U
9. Recipiente Para Tierra
10. Cubierta Transparente del Cepillo
11. Cepillo Giratorio
12. Cabezal Eléctrico de la Barredora
13. Perno y Tuerca de Fijación