Eureka 4710 Series - Manual (Page 6)

Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com 4
1) Remove 2 screws from lens cover
(Fig. 7).
2) Remove lens cover and old bulb.
3) Push in new bulb (Fig.8). Make certain
bulb will not touch lens cover.
4) Replace lens cover and 2 screws.
Change Light Bulb (on some models)
Make sure vacuum is turned off and power cord is unplugged.
!
Fig. 2
Fig. 3 Fig. 4
Fig. 5 Fig. 6
Fig. 7
Fig. 1
Fig. 8
How to replace brush roll or belt
1) Use handle release to lower handle
flat onto floor (Fig. 1).
2) Remove 2 screws from the front side of
brush roll cover (Fig. 2).
3) Lift and remove brush roll cover (Fig. 3).
4) Remove brush roll and belt. Thread
new belt around motor shaft and right
end of brush roll (Fig. 4).
5) Pull right side of brush roll to stretch
belt. Secure right end cap into base
(Fig. 5). Align left end cap with square
in base and push into place.
6) Rotate brush roll 2 turns to center belt.
7) Replace brush roll cover and 2
screws (Fig. 2).
8) Check belt view window to see if white
dots on belt are moving. This indicates
brush roll is turning (Fig. 6).
How to Maintain Your Vacuum Cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged
Check EXT-U Belt. Replace if worn, cut or out of shape.
Avoid touching the motor shaft when checking brush roll or belt.
!
!
Maintain Brush Roll
Motor can become hot with normal use.
Do not remove end caps. Remove hair and threads from brush roll periodically.