Emotiva pmn - Manual (Page 9)

Page 8 Page 9
Rear Panel Layout
Power Plug
IEC 120VAC/60Hz.
Can be converted
to 230VAC/50Hz.
Contact Emotiva for
details.
Speaker Output Terminals
5 way binding posts for left
and right channels. Bridged
configuration is Left + and
Right -. See page 10 for
details.
RCA Inputs and Outputs
2 Channel inputs and non
buffered outputs. For ap-
plication on bridging input
or pass through output, see
pages 10-11 for details.
Auto ON Switch
In the ON Mode, the front
panel switch of the BPA-1 is
used to turn on the amplifier.
In the AUTO Mode, the front
panel switch of the BPA-1
remains on and the amplifier
“wakes up” with the pres-
ence of an audio signal.
Mono/Stereo Switch
Set the switch to Stereo
for 2 channel operation or
MONO for bridged opera-
tion. See pages 10-11 for
details.
Crossover Switch
Set the switch LOWPASS
for use with a subwoofer or
FLAT for full range (20Hz-
20KHz) operation. See
pages 10-11 for details.
Crossover Frequency
In the LOWPASS mode, this
control adjusts the cross-
over point between 50Hz-
150Hz. See pages 10-11 for
details.
Cooling Fan
Thermally controlled cooling
fan runs according to the
amplifier’s thermal condition
for the quietest operation.
Stereo Configuration Bridged Configuration