Emerson CF2800WB - Manual (Page 8)

8
How to Wire
Your Ceiling Fan
TWO SCREWS
SUPPLIED WITH
OUTLET BOX
HANGER
BRACKET
TAB
OUTLET
BOX
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD
ASSEMBLY
NOTE: CEILING COVER,
SUPPLY WIRES AND
FAN WIRES OMITTED
FOR CLARITY.
Figure 18
Figure 19
2. Carefully lift the fan and seat the hanger ball/down-
rod assembly on the hanger bracket that was just
attached to the outlet box (Figure 19). Be sure the
groove in the ball is lined up with the tab on the
hanger bracket (Figure 18).
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
1. Connect the green grounding lead from the hanger
ball and the green grounding lead from the hanger
bracket to the grounding conductor of supply (this
may be a bare wire or wire with green colored
insulation). Securely connect wires with wire
connectors supplied. (Figure 20.)
2. Securely connect the fan motor white wire to the
supply white (neutral) wire using wire connector
supplied (Figure 20). Securely connect the fan
motor black wire and blue wire to the supply black
(hot) wire using wire connector supplied (Figure
20). After connections have been made, separate
the white and green leads from the black and blue
leads. Carefully turn the leads upward and push
the green and white leads into one side of the
outlet box. Then push the black and blue leads into
the other side of the outlet box.
THREADED
STUD (2)
HANGER
BRACKET
WHITE
SUPPLY
(NEUTRAL)
GREEN WIRE (GROUND)
FROM HANGER BRACKET
LISTED WIRE
CONNECTOR (3)
SUPPLY GROUND
WIRE
GREEN WIRE
(GROUND) FROM
HANGER BALL
BLACK FAN
WIRE
BLUE FAN WIRE
BLACK
SUPPLY
(HOT)
WHITE
FAN WIRE
Figure 20
The outlet box and joist must be securely mounted
and capable of supporting at least 50 lbs. Use only a
U.L. outlet box listed as “Acceptable for Fan Support
of 50 lbs. or less”.
WARNING !
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
WARNING !
To avoid possible fire or shock, do not pinch wires
between the hanger ball/downrod assembly and
hanger bracket.
WARNING !
How to Hang
Your Ceiling Fan
FLOOR
AT LEAST
7'
CEILING
Figure 17
The fan must be hung with at least 7' of clearance
from floor to blades (Figure 17).
WARNING
!
Hanger bracket must seat firmly against outlet box. If
the outlet box is recessed, remove wall board until
bracket contacts box. If bracket and/or outlet box are
not securely attached, the fan could wobble or fall.
WARNING
!
1. Securely attach the hanger bracket to the outlet
box using the two screws supplied with the outlet
box. (Figure 18.)
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
WARNING
!