Electrolux U02363 ER 7626 B - Manual (Page 4)

DESCRIPTION OF THE APPLIANCE
4
A
B
C
D
J
I
H
G
F
E
10 - 10 - 10 - 10 - 3 - 3 - 3 - 3 - 3 - 4 1 -
MAX MIN COOL FLOW CONTROL
A- Thermostat control for fridge and freezer compartments
B- Dairy compartment
C- Movable shelf
D- Bottle storage shelf
E- Air circulation slider control
F- Wire shelves
G- Glass shelf
H- Salad drawers
I - Compartment for freezing fresh foods
J- Compartments for frozen food storage
17
Door reversal directions
1. Disconnect from the electricity supply.
2. Remove all loose items, including food, store food
in a cool place.
3. Gently lay the fridge/freezer on its back with the
top held away from the floor by 5-8 cm (2-3
inches) of packing.
4. Remove the feet (B).
5. Remove bottom hinge (A).
6. Remove the freezer door by releasing it from the
middle hinge (C).
7. Unscrew the middle hinge.
8. Slide out the fridge door from pin (D), unscrew pin
(D) and then screw it down into the hinge
provided on the opposite side, after having
removed the small plugs (I) which should then be
fitted on the opposite side.
9. Remove blanking plug (E).
10.Remove door closure device (F) from the upper
door and refit it on the opposite side of the bottom
door.
11. Remove door closure device (F) from the bottom
door and refit it on the opposite side of the upper
door.
12.Refit the blanking plug (E) on the opposite side.
13.Refit the fridge door and replace the middle hinge
to the left hand side.
14.Replace the door and bottom hinge (A) on the
opposite side.
15.Refit the feet (B).
Attention
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdryer on a low setting.
D752
E
F
D715 PIED/M
A
B
B
I
I
I
D
D590
P R 2 4 / 2
C
Door closure device
The appliance is provided with a door closure device
which guarantees correct closing of the doors.
Remove blanking plugs E and transfer the closure
device F to the opposite door position and refit the
blanking plugs into the vacant holes.