Electrolux DD 8795 - Manual (Page 17)

68
1
2
3
4
12
14
13
13
10a
10b
11
Fig. 10
Extractor version
Filter version
Fig. 11
• Fix the sides of the
cooker hood by
fastening the pins (10a)
to the sides of the
fastening screws (10b).
Only DD 8794 (not UK):
side panels are available
as a special accessory
please contact your local
Service Centre (or see
paragraph “Special
Accessory”).
Block the sides sliding
the two tabs outwards
(11).
• Make electrical
connection (12), but leave the hood disconnected from the home
general electric panel.
• In the case that it is decided to use the cooker hood in the suction
version, then place one of the two flanges provided in the exit hole
(13 – Suction). Attention! The tall flange should be used when a
telescopic chimney is required to be mounted (this item should be
ordered – see special accessories), the short flange is to be used in
all other cases.
• Remount the grease filter and the front panels
according to the numbering
noted also on the back of each
screen (from 1 to 4 from the top
to the bottom).
• Connect the hood the the home
general electric panel and check
if the hood work properly.