Electrolux 54850 S - Manual (Page 32)

Operating instructions
32
- Indicator light of the
programme in progress
is flashing.
- in the digital display
appears:
The machine does not fill
with water
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean out the sink spigot
connection. The sink spigot connection is
blocked.
Check the water drain
hose connection.
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
The water inlet hose has not
been correctly laid or it is
bent or squashed. Check the water inlet hose
connection.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Fault code / Malfunction Possible cause Solutions
- Indicator light of the
programme in progress
is flashing.
- in the digital display
appears:
The dishwasher will not
drain
Close the water tap and
contact the Service Force
Centre.
Protection against flooding is
active.
- Indicator light of the
programme in progress
is flashing.
- in the digital display
appears:
What to do, when...
Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...a flashing fault code appears
The intervention of an alarm is indicated by:
- indicator light of the programme in progress is flashing
- a fault code visible in the digital display.
Open the door and carry out the following suggested corrective actions (see
following chart).