Placing your original document, Stand-alone copying, Basic copying – Epson Stylus CX3200 User Manual

Page 6: Changing copy settings, Number of copies, Paper size, Lighten or darken

(3621 6W\OXV &;

Placing Your Original Document

Place your document face-down on the glass, in the corner
shown below. Move your document about 0.1 inch from the
top and side edge so your entire document is scanned.

Note:
If you place your document against the guides, the edges next to the
guides won’t be scanned.

If you need to scan a thick document, such as a book, you can
remove the scanner lid to scan. Gently press down the original to
keep it flat on the document table. Be sure to replace the scanner lid
when you’re finished.

Stand-Alone Copying

Basic Copying

1. Place your document face-down on the glass, as shown to

the left.

2. The default copy settings are displayed on the control panel.

Change any necessary copy settings, as described in
“Changing Copy Settings” below.

3. Press the

Color Copy

button (for color copies) or

B&W

Copy

button (for black and white copies). Your document

is scanned and then printed. If you’re using the

2-up

Copy

Mode setting (see “Type of Copies” on page 7), repeat these
steps for your second page.

Note:
Your copied image size may not be the exact same size as your
original.

Changing Copy Settings

The current copy settings are shown on the LCD screen. You
can change copy settings using the control panel, as described
below.

When you finish changing a setting, press the

Stop

button.

Note:
To clear a setting, press the Reset button. To clear all the setting
changes you’ve made, press and hold the Reset button for at least 3
seconds.

If you’ll be changing the Copy mode setting (as described in “Type of
Copies” on page 7), select your Copy mode before selecting any
other copy settings.

Number of Copies

Press the

- Copies

buttons. (If you’re using the

2-up

Copy

Mode setting (see “Type of Copies” below), you can’t select the
number of copies.)

Paper Size

Press a

button until you see

Paper size

on the LCD

screen. Then press the

- Value

buttons to select the size of

the paper you loaded, either

Letter

4 Ч 6

5 Ч 7

, or

(8.3 × 11.7 inches).

Lighten or Darken

Press a

button until you see

Lighter/Darker

on the LCD

screen. Then press the

- Value

buttons to lighten or darken

your copies.

Move the
document in
about 0.1 inch
from the edges

Current settings are shown here

Menu
buttons

Copies/Value
buttons (+ and -)

Stop
button

Reset
button