Electrolux EWT 9120 W - Manual (Page 9)

Untying
2
3
1b a
1a 1b
2a 2b
3 4
To install your washing machine at the same level
as surrounding furniture, proceed as shown on
picture 4.
Water supply
Install the supplied water inlet hose at the rear of
your washing machine by proceeding as follows.
Do not reuse an old hose. The water inlet hose can
not be extended. If it is too short, please contact
the after-sales service.
1 1 2
Open the water inlet tap. Check there are no leaks.
Drainage
Fit the U-piece on the
drainage hose. Place
everything in a drainage
point (or in a sink) at a
height of between 70
and 100 cm. Ensure it is
positioned securely. Air
must be able to enter
the end of the hose, to
avoid any risk of siphon-
ing.
The drain hose must never be stretched. If it is too
short, contact an engineer.
Electrical connection
This washing machine must only be connected in
single-phased 230 V. Check the fuse size: 13 A for
230 V. The appliance must not be connected with
an extension lead or multi-plug adaptor. Ensure
that the plug is earthed and that it is in accordance
with current regulations.
Positioning
Position the appliance on a flat and hard surface in
a ventilated location. Ensure the appliance does
not come into contact with the wall or other furni-
ture. Accurate levelling avoids vibrations, noise
and prevents the appliance from moving when
running.
MINI 70 cm
MAXI 100 cm
Environment
Disposing of the appliance
All materials carrying the symbol are re-
cyclable. Dispose of them at a waste collec-
tion site (enquire at your local council) for collection
and recycling. When disposing of your appliance,
remove all parts which could be dangerous to oth-
ers: cut off the power supply cable at the base of
the appliance.
The symbol
on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of
electrolux 9