Powerplus POWXG9447 GARD EN PUMP 1200W SS EN - Manual (Page 8)

POWXG9447
EN
Copyright © 2014 VARO NV P a g e | 8 www.varo.com
PROBLEM POSSIBLE CAUSE SOLUTION
The heat-sensitive
switch cannot switch-off
the pump 1. Over-load of the electric motor
due to friction caused by impurities
entering the motor 1. Wash the shell of the pump
with pressured water
The switch of the pump
is always OFF or ON 1. No non-return valve installed on
the suction hose 1. Check to see if a valve is
installed on the suction hose
Frequent switching
ON/OFF of the pump
switch (when used for
household water supply
system) 1. Rupture of the rubber envelope
in the pressure tank 1. Replace the rubber envelope or
the container
2. No compressed air in the
container 2- Use an adequate valve and
conned this with a compressed air
supply at 1.8 bar, and fill the
container with air
12 INSTRUCTIONS FOR USE POWXG9447 EDWC
See separate manual in the packaging.
13 WARRANTY
 This product is warranted as provided by law for a 36 months period effective from the
date of purchase by the first user.
 This warranty covers all material or production flaws excluding : batteries, chargers,
defective parts subject to normal wear & tear such as bearings, brushes, cables, and
plugs, or accessories such as drills, drill bits, saw blades, etc. ; damage or defects
resulting from maltreatment, accidents or alterations; nor the cost of transportation.
 Damage and/or defects resulting from inappropriate use also do not fall under the
warranty provisions.
 We also disclaim all liability for any bodily injury resulting from inappropriate use of the
tool.
 Repairs may only be carried out by an authorized customer service center for Powerplus
tools.
 You can always obtain more information at the number 00 32 3 292 92 90.
 Any transportation costs shall always be borne by the customer, unless agreed otherwise
in writing.
 At the same time, no claim can be made on the warranty if the damage of the device is the
result of negligent maintenance or overload.
 Definitely excluded from the warranty is damage resulting from fluid permeation, excessive
dust penetration, intentional damage (on purpose or by gross carelessness), inappropriate
usage (use for purposes for which the device is not suitable), incompetent usage (e.g. not
following the instructions given in the manual), inexpert assembly, lightning strike,
erroneus net voltage. This list is not exhaustive.
 Acceptance of claims under warranty can never lead to the prolongation of the warranty
period nor commencement of a new warranty period in case of a device replacement.
 Devices or parts which are replaced under the warranty therefore remain the property of
Varo NV.
 We reserve the right to reject a claim whenever the purchase cannot be verified or when it
is clear that the product has not been properly maintained. (Clean ventilation slots, carbon
brushes serviced regularly, etc.).
 Your purchase receipt must be kept as proof of date of purchase.