Powerplus POWXG9447 GARD EN PUMP 1200W SS EN - Manual (Page 5)

POWXG9447
EN
Copyright © 2014 VARO NV P a g e | 5 www.varo.com
 The pump must not run dry, as this will cause irreparable damage.
 Always disconnect the pump from the mains supply before cleaning or maintenance.
 Clean the chambers from time to time, rinsing them with clean water, to ensure they are
not clogged with dirt.
8 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
8.1 Cleaning
Under normal conditions, the water pump is free of maintenance. However, the pump should
not be placed in the open air during rain, in a humid place, or dirty or frozen environment.
 Freezing, idling or blocking by impurities should be avoided.
 Always disconnect the power supply before maintenance of the pump.
 If the power cable is damaged, it must be replaced by professional personnel. Damage
caused by short circuiting is not included in scope of the guarantee.
 If trouble with the pump is experienced, guaranteed repairs must be carried out by an
authorized maintenance center.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
8.2 Cleaning of the built-in filter.
Your pump is equipped with a built-in filter. Regularly remove the dirt that fixes on the mazes
of the filter.
To clean the filter unit :
 Switch off the pump & pull plug from power supply socket

Unscrew the filter lid from it’s housing
 Take out the filter casette and clean it under running water.
 reposition the filter cassette and close the lid again, plug in the power plug and switch the
pump back on.