Powerplus POWXG9006 HIGH PRESSURE CLEANER 163CC EN User Manual

Page 7

POWXG9006

P a g e

| 7

www.varo.com

Connect the high pressure hose connector to the
connector on the underside of the gun assembly
ensuring that it is tight. Do not over tighten as this
could damage both the connectors.

9.4

High pressure lance safety lock

In order to prevent accidental operation of the
high-pressure lance, the gun is fitted with a safety
lock. To engage the safety lock (picture1, part 5)
release the trigger and engage the safety lock
between the trigger and the gun body.

9.5

Connecting the hose

The water inlet connector (picture 3, part 26) is fitted with a particle filter.
Do not run the unit without filter.
Based on the water quality the filter must be checked and cleaned from time to time.
In case there are dirt particles in the water supply, the filter must be cleaned before each use.
Otherwise the performance of the unit will be decreased or the pump might get damaged.

Screw the male, water inlet connector (picture 3,
part 26) onto the pressure washer water inlet.
Fit a female hose connector to your hose pipe and
then connect the female connector onto the male
connector.

Connect the high-pressure hose to the delivery
pipe outlet (picture 3, part 24). Turn on the water
supply and squeeze the gun trigger (picture 1, part
6) until the water flows in a steady stream through
the lance. Do not use water which exceeds 40°C.