Powerplus POWXG9006 HIGH PRESSURE CLEANER 163CC EN User Manual

Page 6

POWXG9006

P a g e

| 6

www.varo.com

9 BEFORE OPERATION

To prepare your pressure washer for operation, you will need to perform these tasks:

Add oil to engine crankcase.

Add fuel to fuel tank.

Connect high pressure hose to spray gun and pump.

Connect water supply to pump.

Attach nozzle extension to spray gun.

Note: the engine and pump on your new pressure washer will often have an improved
performance after a break of several hours.

9.1

Add oil to the engine crankcase

Do not attempt to start the pressure washer
without filling the engine crank case (picture1, part
14) with the proper amount and type of oil (see
technical data). In delivery status the pressure
washer has no oil inside the engine crank case.
Operating the unit without oil will cause engine
damage. Place the machine on a level surface
and remove the oil filler cap.

Add engine oil to at least half of the dipstick

9.2

Add fuel to fuel tank

The pressure washer is powered by a four-stroke
engine, which uses unleaded petrol fuel.
Use a suitable funnel to fill in the fuel to the
engines fuel tank (picture 1, part 9). Do not spill
any fuel or overfill the tank. The fuel tank should
not be filled above the top of the fuel filter.

9.3

Connect high pressure hose to spray gun and pump.

Fit the lance to the gun (picture 1, part 6). Grip the
end of the gun and screw the lance onto the gun
ensuring it is tight. Do not over tighten as this
could damage both the connectors.