Powerplus POWXG7201 CULTIVATOR 1200W EN - Manual (Page 11)

POWXG7201
EN
Copyright © 2015 VARO P a g e | 11 www.varo.com
13 TROUBLE SHOOTING
Problem Possible causes Remedy
Motor does
not start No electricity Check mains connection
Defective cable Check cable, plug in, replace if required, or have
it repaired by a qualified person
Defective safety
switch/plug combination Arrange for repair in a specialist workshop
Overheat protection
actived 1. Working depth too large, set to the shorter
depth
2. Blades blocked, remover the blockage
3. Soil too hard, select correct work depth and
forwards and backwards several times while
slowly down the operation speed.
4. Wait till the motor cool down for around 15
minutes before rework
Abnormal
noises Blade is jammed Switch off wait till complete stop. Remove the
objects
Lubrication running out Arrange for repair in a specialist workshop
Loose bolts, nuts or other
securing components Tighten all components, contact specialist
workshop if noises prevail
Abnormal
vibrations Blades damaged or worn Replace or have it checked by an specialist
workshop
Working depth too large Set to correct working depth
Poor
scarification
results Working depth too small Set to correct working depth
Worn blades Replace or have it checked by an specialist
workshop
14 TECHNICAL DATA
Power supply voltage: 230V~ 50Hz
Power consumption: 1200W
Idle Speed: 350 min
-1
Working width: 400 mm
Working depth max.: 200 mm
15 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
72 dB(A)
Acoustic power level LwA 93 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration) 2.6 m/s² K = 1,5 m/s²