Powerplus POWXG4050 LEAF BLOWER/VACUUM 31CC EN - Manual (Page 7)

POWXG4050 EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
3.Slowly press the primer bulb(11) 6-8
times,until the gas/oil mixture flows in and
out of the discharge hose above the fuel
tank.
4. Your unit is designed with a 3 position choke: FULL CHOKE “ ”, PARTIAL CHOKE
“ ”, and RUN “ ”.
Move choke lever to FULL CHOKE “ ” position.
Remark: You can use partial choke when the machine is not completely warmed up and/or
as an intermediate position (between full choke and run), when setting the choke back.
Partial choke can also be used when the motor is warmed up but does not start
immediately.
5.Hold the throttle trigger (8) with a hand,at
the same time,to pull the recoil starter(9)
2
—3 times.
6.The motor may start,or it may be required
to pull on the recoil starter(9) until the
motor starts.
7. Wait 10 sec. after unit starts then move choke lever to position 3.
8. Position the suction mouth on the area to
be cleared.from side to side with the nozzle
a few inches above the ground or floor.
Move the Blower/Vac slowly, while
accumulating a pile of debris