Powerplus POWXG3016 BRUSH CUTTER 42,7CC EN - Manual (Page 4)

POWXG3016
EN
Copyright © 2014 VARO P a g e | 4 www.varo.com
Denotes risk of personal
injury or damage to the tool. Wear approved hearing
protection and safety glasses.
CE Conform de Europese
toepasselijke standards op
het gebied van veiligheid.
Wear good and sturdy gloves!
Keep a minimum distance of
15m between the machine
and third parties during use.
Wear good and solid working
clothes!
Watch out for particles
generated by the cutting
installation.
The exhaust fumes are toxic
and can cause suffocation!
Use the cutting installation
exclusively in combination
with the shrub knife. WATCH OUT: Fire hazard!
Petrol and vapour are easily
inflammable!
Use the cutting installation exclusively in combination with the threading
head.
5 GENERAL SAFETY INSTRUCTIONS
Read all safety warnings and instructions.
5.1 Working area
 Keep working area clean and well lit. Untidy and dark areas can lead to accidents.
 Do not operate tools in potentially explosive surroundings, for example, in the presence of
inflammable liquids, gases or dust. Tools create sparks which may ignite the dust or fumes.
 Keep children and bystanders at a distance when operating a tool. Distractions can cause
you to lose control of it.
5.2 Personal safety
 Stay alert, watch what you are doing and use common sense when operating a tool. Do
not use a tool when you are tired or under the influence of drugs, alcohol or medication. A
moment of inattention when operating a tool may result in serious personal injury.
 Use safety equipment. Always wear eye protection. Using safety equipment such as a
dust mask, non-skid safety shoes, a hard hat, or hearing protection whenever it is needed
will reduce the risk of personal injury.
 Remove any adjusting keys or spanners before turning on the tool. A spanner or key left
attached to a rotating part of the tool may result in personal injury.
 Do not reach out too far. Keep your feet firmly on the ground at all times. This will enable
you retain control over the tool in unexpected situations.
 Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and
gloves away from the tool. Loose clothes, jewellery or long hair can become entangled in
the moving parts.
 Inspect the entire machine for loose parts (nuts, bolts, screws, etc.) and any damage.
Repair or replace as necessary before using the machine.