Powerplus POWXG2015 HEDGE TRIMMER 25,4CC 600MM EN - Manual (Page 13)

POWXG2015 EN
Copyright © 2014 VARO P a g e | 13 www.varo.com
 Check the sparking plug and replace it if too much of the firing tip has been burnt off.
 Keep the blade in a dry place
– out of the reach of fire.
12 STARTING UP AFTER LONGER PERIODS OF INACTIVITY
 Remove the sparking plug.
 Quickly pull the starter cord right through several times in order to remove oil and deposits
in the engine compartment.
 Check the sparking plug, replace it if necessary and screw it in.
 Fill the petrol tank with the 2-stroke mixture.
13 TECHNICAL DATA
Engine displacement 25.4cc
Construction Hand-held
Weight 6.1kg
Fuel tank capacity 600ml
Blade length 600mm
Blade speed 1650r/min
Max. engine speed 8500r/min
Engine idle speed 3400r/min
Clutch engagement speed 4300r/min
Output power 900W
Engine oil / gasoline mixed ratio 1:40
14 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA 91 dB(A)
Acoustic power level LwA 114 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration): Max 8.4 m/s² K = 1.5 m/s²
15 SERVICE DEPARTMENT
Damaged switches must be replaced by our after-sales service department.
If the connecting cable (or mains plug) is damaged, it must be replaced by a special
connecting cable which is available from our service department. Replacement of the
connecting cable should only be carried out by our service department (see last page) or by
a qualified specialist (qualified electrician).