Powerplus POWXG2007 HEDGE TRIMMER 550W 525MM EN - Manual (Page 5)

POWXG2007 EN
Copyright © 2015 VARO P a g e | 5 www.varo.com
 When cutting, make sure do not touch objects such as wire fences or plants frame-holder.
Doing so can damage the blade beam.
 Hold the electric hedge trimmer with both hands firmly, with one hand on the rear and with
the other hand on the front handle. Thumb and fingers must firmly embraced.
7 OPERATION
7.1 Starting the machine
 Switching on: press both the trigger switch (1) and the front handle trigger (2) at the same
time.
 Switching off: release one of the switches.
 The mechanical blade brake makes the blades stop immediately within 0.5 sec. the small
flash in the area of the upper ventilation slots is normal and does no harm to you or the
machine.
7.2 Cutting hedge
Before you start your work, select branches with a diameter not bigger than 16mm and cut
them with a pruning shear. A trapezoidal cut corresponds to the natural, growth of plants and
results in optimal hedge growing.
 First cut the sides from the bottom to the top. Cut the upper part giving it the shape you
prefer, in a straight horizontal form, roof-like or rounded.
 The safety blade has laterally rounded and staggered cutting teeth to reduce danger of
injury. The additional shock protection avoids inconvenient kickback when the blades
come into contact with walls, fences etc.
 If the blades are jammed or blocked by obstacles, switch the motor off immediately, pull
the plug, and then remove the object jamming the blades.
 Caution! Metal obstacles like fences etc. may damaged the cutting blades.
 Always make sure to keep the extension cord behind your back and to start cutting the
hedge at the point nearest to the supply socked. Therefore plan your working direction
before staring.
8 CLEANING AND MAINTENANCE
Warning! Before performing any work on the equipment, pull the power
plug.
 Check your machine regularly before starting the work.
 Damaged cutting blades have to be repaired or exchanged by a qualified service man
before working with the machine
 After each cutting operation, clean the cutting blade with a soft brush and cloth with
lubricating fluid oil and spray a thin layer of fluid protective oil on the completes blade.
 Always keep the ventilation slots in motor housing clean
 Never clean or spray a machine with water .clean the motor housing only with a moist
cloth and never apply detergents or solvents! These could ruin the plastic parts of the
machine. Finally, dry the motor housing carefully.
 Store the machine with the supplied protection cover.
 Only use original accessories and spare parts.