Powerplus POWXG2007 HEDGE TRIMMER 550W 525MM EN - Manual (Page 3)

POWXG2007 EN
Copyright © 2015 VARO P a g e | 3 www.varo.com
Never operate the machine in
the rain or in damp or wet
condition. Moisture is a shock
hazard.
Remove the plug from the mains.
Class II - The machine is double
insulated; Earthing wire is
therefore not necessary. In accordance with essential
requirements of the European
directive(s).
5 GENERAL POWER TOOL SAFETY WARNINGS
Read all safety warnings and all instructions. Failure to follow all warnings
and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference. The term "power
tool" in the warnings refers to your mains operated (corded) power tool or
battery operated (cordless) power tool .
5.1 Work area
 Keep work area clean and well lit. Cluttered and dark areas invite accidents.
 Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or
fumes.
 Keep children and bystanders away while operating a power tool. Distractions can cause
you to lose control.
5.2 Electrical safety
 Always check that the power supply corresponds to the voltage on the rating plate.
 Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching
outlets will reduce risk of electric shock.
 Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges
and refrigerators. There is an increased risk of electric shock if your body is earthed or
grounded.
 Do not expose power tools to rain or wet conditions. Water entering a power tool will
increase the risk of electric shock.
 Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power
tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled
cords increase the risk of electric shock.
 When operating a power tool outdoors, use an extension cord suitable for outdoor use.
Use of a cord suitable for outdoor use reduces the risk of electric shock.
 If operating a power tool in a damp location is unavoidable, use a residual current device
(RCD) protected supply. Use of an RCD reduces the risk of electric shock.
5.3 Personal safety
 Stay alert, watch what you are doing and use common sense when operating a power
tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or
medication. A moment of inattention while operating power tools may result in serious
personal injury.
 Use safety equipment. Always wear eye protection. Safety equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing protection used whenever conditions require
will reduce personal injuries.
 Avoid accidental starting. Ensure the switch is in the off position before plugging in.
Carrying power tools with your finger on the switch or plugging in power tools that have
the switch on invites accidents.