Powerplus POWX134 MULTITOOL 180W +100ACC EN - Manual (Page 9)

POWX134
EN
Copyright © 2013 VARO P a g e | 9 www.varo.com
7.6 LED light
Pic 14
 If you work in dark condition and want
see clearly the work area ,please turn on
the LED
 Push the LED button (6),the LED is on
8 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
8.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
8.2 Replacing the carbon brushes
Fig 15
 If the multi tool motor sputters or
completely stops working , this means
the carbon brushes have worn down.
 The multi tool has two carbon brushes.
Always replace both carbon brushes
at the same time.
 Use a small screwdriver to open the
round cover .Replace the old carbon
brushes with new ones, close the
cover.
9 TECHNICAL DATA
Voltage / frequency 230V / 50Hz
Power input 180W
No load speed 10.000 – 34.000 min-1
Spring chuck Ф 10 x 15mm