Powerplus POWX1152 HAMMER DRILL 1250W EN - Manual (Page 7)

POWX1152
EN
Copyright © 2014 VARO NV P a g e | 7 www.varo.com
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Re-sharpen or replace blunt drill bits.
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9.2 Replacing Coal Brushes
Remove and check the carbon brushes regurarly. Replace when they have worn down to the
limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon
brushes must be replaced at the same time. Only use original carbon brushes.
10 TECHNICAL DATA
Rated Voltage 220-240 V
Rated Frequency 50 Hz
Rated Power 1250 W
Rotation speed 800 min
-1
Protection class II
Drill capacity concrete 30 mm
Drill capacity steel 13 mm
Drill capacity wood 40 mm
Impact rate 3900 min
-1
Cable length 3 m + VDE plug
Chuck type 13 mm Keyless chuck
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
92 dB(A)
Acoustic power level LwA 103 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration) 15,1 m/s² K = 1,5 m/s²