Powerplus POWX1020 HEAT GUN 2000W EN - Manual (Page 7)

POWX1020
EN
Copyright © 2014 VARO NV P a g e | 7 www.varo.com
8.6 Stationary use (Fig. B)
This tool can also be used in stationary mode.
 Place the tool onto the workbench.
 Secure the cable to prevent pulling the tool off the workbench.
 Carefully switch the tool on.
Make sure that the nozzle always points away from you and any
bystanders.
Make sure not to drop anything into the nozzle.
8.7 Mounting the correct accessory
These accessories are not supplied with the tool. They are available in the
specialized tool shop.
Icon Description Purpose
Glass protection nozzle Protecting windows when stripping
frames
Spoon reflector nozzle Soldering pipes
Cone nozzle Welding, shrink sleeving (heat
concentrated over small area)
Fish tail surface nozzle Drying, thawing (heat spread over
wider area)
Scraper Stripping paint and varnish
Make sure that the tool is switched off and the nozzle has cooled down.
Set the desired accessory onto the nozzle.
8.8 Cooling down
The nozzle and accessory become very hot during use. Let them cool down before attempting
to move or store the tool.
Place this hot air gun vertically during cooling time or rest after operation.
 To reduce the cooling time, switch the tool on at position ‘I’ and let in run for a few
minutes.
 Switch the tool off and let it cool down for at least 30 minutes.