Powerplus POWX088 DOUBLE MIXER 1600W EN - Manual (Page 6)

POWX088 EN
Copyright © 2013 VARO P a g e | 6 www.varo.com
 And then loose your hand.
8 OPERATION
8.1 Switching on and off
To switch the tool on, press the switch (1) and hold it down. To switch the tool off, release the
switch (1).
8.2 Continuous operation
To switch on continuous operation: press the switch (1) up to the stop and at the same time
press the locking button (2). The switch (1) locks, and continuous operation is activated.
To switch off continuous operation: press the switch (1) again and then let go. The lock on
the switch (1) is released, and continuous operation is deactivated.
9 MOTOR ELECTRONICS / OPERATING MOTOR ELECTRONICS
9.1 Starting current limiting
The electronically controlled soft start ensures that the machine starts smoothly. This also
prevents spray from thin liquids when the tool is switched on.
The lower starting current means that a 16 A fuse is large enough for the machine.
9.2 Mechanical speed regulator operation instruction
When the machine is under STOP condition, please turn the knob switch to change the speed;
When you can not finish changing speed completely by turn the knob switch, please turn the
shaft paddles slightly and change speed.
9.3 Electronic speed regulator operation instruction:
Turn on the power switch first, then turn the regulator switch which located in the left handle to
get your wanted speed.
10 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
 Liquids must not be allowed to get into the inside of the appliance. Use a soft doth to clean
the casing. Never use gasoline, solvents or cleaning agents that are aggressive on
plastics.
 Wherever possible, always clean the mixing tools immediately after finishing work.
 Clean the air vents on the motor housing from time to time.
 When the carbon brushes have run out ,the tool switches itself off.
 Check the carbon brushes after approx. 100 hours of operation; if necessary replaced
them and clean the motor housing.