Powerplus POWX087 CONCRETE/PAINT MIXER 1600W EN - Manual (Page 5)

POWX086 & 087
EN
Copyright © 2013 VARO NV P a g e | 5 www.varo.com

Do not reach out too far. Keep your feet firmly on the ground at all times. This will enable
you retain control over the power tool in unexpected situations.

Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and
gloves away from the power tool. Loose clothes, jewellery or long hair can become
entangled in the moving parts.
 If there are devices for connecting dust extraction and collection facilities, please ensure
that they are attached and used correctly. Using such devices can reduce dust-related
hazards.
5.4 Power tool use and care

Do not expect the power tool to do more than it can. Use the correct power tool for what
you want to do. A power tool will achieve better results and be safer if used in the context
for which it was designed.
 Do not use the power tool if the switch cannot turn it on and off. A power tool with a
broken switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store power tools, when not in use, out of the reach of children and do not allow people
who are not familiar with the power tool or these instructions to operate it. Power tools are
potentially dangerous in the hands of untrained users.

Maintain power tools. Check for misalignment or jammed moving parts, breakages or any
other feature that might affect the operation of the power tool. If it is damaged, the power
tool must be repaired. Many accidents are caused by using poorly maintained power
tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to jam and are easier to control.
 Use the power tool, accessories and cutting tools, etc., in accordance with these
instructions and in the manner intended for the particular type of power tool, taking into
account the working conditions and the work which needs to be done. Using a power tool
in ways for which it was not intended can lead to potentially hazardous situations.
5.5 Service
 Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
 .
6 SPECIFIC SAFETY WARNINGS
 It is only possible to work safely with this tool if you read these instructions for its use and
maintenance thoroughly and follow the instructions meticulously.
 Please also observe the other safely instructions included in the delivery scope of every
tool.
 Before using the tool, always check the flexible supply lead and the plug. Any faults must
be repaired by an expert.
 The tool must not be used in damp and wet rooms, in the open in rain, fog, snow or in any
area in which there is a risk of explosion.
 Before connecting the tool to the electricity mains, make sure that it is switched off. Check
the position of the corresponding switch where necessary.
 Take care with long hair and fashion accessories. Always wear close-fitting, properly
fastened clothing without any loose parts when working with the tool.
 Secure the container holding the substance you wish to mix on the floor to prevent it
moving.