Powerplus POWX0440 FINISHING SANDER 330W EN - Manual (Page 7)

POWX0440 EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
8.3 Guide handle
This tool has a guide handle (1) on the front of this tool which should be used only with both
handles.
8.4 Using the dust collection box (3)
8.4.1 To install:
pull and slide dust collection box (3) into the dust extraction port (8), make sure the latches on
the right and left of the dust collection box (3) are into place and they are secured before
beginning operation.
8.4.2 To remove:
When removing the dust collection box, follow the above procedure in reverse order. (See Fig.
6) If the dust collection box is full, you can remove it from this tool and open the cover of box,
empty dust, wood bust, etc. in the body, finally clean the dust collection box.
8.4.3 To remove:
Hold the front cover with one hand and the rear cover with the other.
There are release buttons on the sides of the rear cover. Using your thumb and fingers, press
the release button in and pull the rear cover off.
8.4.4 To install:
When assembling the dust collection box, follow the above procedure in reverse order.
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DETAILS
Rated Voltage 230-240V
Rated Frequency 50Hz
Rated Power 330W
Rotation speed 6000-11000min
-1
Oscillating frequency 12000-22000min
-1
Sanding plate size 115x230mm
Cable length 3m