Powerplus POWX0440 FINISHING SANDER 330W EN - Manual (Page 6)

POWX0440 EN
Copyright © 2013 VARO P a g e | 6 www.varo.com
 Remove dust and other waste matter in an environmentally safe way.
 Take special care when sanding lead based paint:
 All persons entering the work area, must wear a mask specially designed for protection
against lead paint dust and fumes.
 Children and pregnant women must not enter the work area.
 Do not eat, drink or smoke in the work area.
7 ASSEMBLY
7.1 Fitting the sanding sheets
7.1.1 Hook-and-loop system (Fig 1)
 To attach sand paper (7), first remove all dirt or foreign matter from the sanding plate (5).
 Then attach the sand paper to the sanding plate, using the hook-and-loop system of the
sand paper and the sanding plate.
 Make sure the perforations in the paper coincide with those on the sanding plate, to
ensure optimal dust collection.
 The sand paper should rest flush on the sanding plate and must not come loose.
WARNING: When removing the sanding paper, follow the above procedure
in reverse order.
7.1.2 With paper clamps (4)
 Open the paper-clamps (4) on both sides of the sanding plate (5) as the direction of arrow
shows on the Fig. 2 and remove the worn-out sand paper.
 Place a new sand paper on the sanding plate observing the holes in the sand paper fit to
the holes of the sanding plate.
 Bend the paper to the sanding plate and fasten one clamp (4) first. Press the sand paper
against the sanding plate, bend the other end and fasten second clamp.
Attention: This finishing sander is not suitable for wet sanding jobs.
WARNING: The sand paper must be fitted firmly on sanding plate and
should not come loose.
8 OPERATION
8.1 Switch on and off
Connect the plug to the power supply.

Switch the power tool on: push the ON/OFF switch button (2) forwards onto the “I”
position.
 Switch the power tool off: pull the ON/O FF switch button backwards to the “O” position.
WARNING: Never use the machine for sanding magnesium work piece.
8.2 Speed regulation (6)
Turn to the speed adjusting dial to regulate the vibration speed. The number of vibration
varies of 6000 to 11000 per minute.