Powerplus POWX019 IMPACT WR ENCH 18V EN - Manual (Page 7)

POWX019
EN
Copyright © 2011 VARO P a g e | 7 www.varo.com
6.3 Batteries
Your wrench's battery pack is equipped with Nickel-Cadmium rechargeable batteries. Length
of service from each charging will depend on the type of work you are doing. The batteries in
this tool have been designed to provide maximum trouble-free life. However, like all batteries,
they will eventually wear out. Do not disassemble the battery pack and attempt to replace the
batteries. Handling of these batteries, especially when wearing rings and jewelry could result
in a serious burn.
To obtain the longest possible battery life, we suggest the following:
§ Store and charge your batteries in a cool area. Temperatures above normal room
temperature will shorten battery life.
§ Never store batteries in a discharged condition. Wait for battery to cool and charge
immediately.
§ All batteries gradually lose their charge. The higher temperature, the quicker they lose
their charge. If you store your tool for long periods of time without using recharge the
batteries every month or two This practice will prolong battery life.
Caution: Once the batteries become fully charged, we recommend that you
unplug the charger from power supply and remove from battery pack.
6.4 Switch action
Caution: Before inserting the battery pack into the tool, always check to see
that the ON/FF switch (6) actuates properly and returns to the "OFF"
position when released.
§ To start the tool, simply pull the ON/FF switch (6), speed is increased by increasing
pressure on the switch. Release the ON/FF switch (6) to stop.
6.5 Reversing switch action
Caution: Always check the direction of the rotation before operation.
§ Use the reverse switch (2) only after the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may damage the tool.
§ When not operating the tool, always set the reverse switch (2) to the neutral position
§ Push the reverse switch (2) in from the right for counterclockwise rotation. When the
reverse switch (2) is in neutral position, the ON/OFF switch (6) cannot be pulled.
Caution: Do not change the direction of rotation while the tool is running,
The tool may be damaged.
7 ASSEMBLY OF ATTACHMENTS
§ Selecting correct socket.
§ Always use the correct size socket for bolts and nuts. An incorrect size socket will result in
inaccurate and inconsistent fastening torque and /or damage to the bolt or nut. Refer to
accessories section for socket size.