Powerplus POWX0079LI ANGLE GRINDER 18V LI-ION 115MM ONE FITS ALL EN - Manual (Page 8)

POWX0079LI EN
Copyright © 2014 VARO p a g e | 8 www.varo.com
 To switch on the angle grinder, push the lock-off button (9) to left or right and squeeze the
ON/OFF switch trigger (4)
 When you release the switch trigger, the tool turns off.
 Do not let go of grinder until it has stopped running.
The wheel continues to rotate after the tool is switched off.
9 OPERATON MODES
9.1 Grinding
Hold the handle (3) and auxiliary handle (6) firmly and
switch on. Avoid blocking the ventilation slots with your
hand, as this may cause the grinder to overheat. Let the
disc reach full speed. Apply the grinder to the item.
Maximum effect is achieved when the grinder is held at
an angle of 15-30°in relation to the item. Move the
grinder gently along the item. Give the grinder time to
work. It is rarely necessary to press the disc hard against the surface to be worked. Sparks
can occur in the motor compartment during use. This is normal and does not mean the grinder
is defective. Switch off the grinder after use.
10 FLANGE ARRANGEMENTS WHEN USING GRINDING WHEELS
10.1 Flange arrangements when using a depressed centre or straight grinding wheel
1 Clamping flange
2 Flange nut
11 CLEANING AND MAINTENANCE
Always disconnect the battery pack from the angle grinder before making
any adjustment or attaching any accessories.
11.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.