beautypg.com

Inserting and removing the battery (fig 2), Replacing saw blades (see fig. 3), Angle cutting adjustment (see fig 4) – Powerplus POWX0075LI JIGSAW 18V LI-ION ONE FITS ALL EN User Manual

Page 8: Switch on and off (see fig. 5), Cutting-orbital or straight (pendulum switch)(7)

background image

POWX0075LI

EN

Copyright © 2013 VARO

P a g e

| 8

www.varo.com

NOTE: Remove battery pack from charger stand which use your thumb or
fingers, press the battery

’s release button in and pull the battery pack off at

the same time.

8.2

Inserting and removing the battery (Fig 2)

 Remove the battery pressing the battery latches and at the same time pull the battery

pack off.

 To insert the battery, push the battery pack onto the contacts of the tool.

8.3

Replacing saw blades (See Fig. 3)

Disconnect the battery pack (5) from the cordless jig saw.
 Pull the lever of quick-change blade clamping holder.
 Slide the saw blade (11) into the locating groove with teeth pointing forward. Make sure

that the back edge of the blade fits into the blade clamping holder (10) and then release
the lever of quick-change blade clamping holder.

NOTE: Make sure that the back of the saw blade engages in the slot of the
guide roller (9).

 Mounting battery pack (5) onto jig saw

’s body and runs smoothly before using it to cut any

materials.

8.4

Angle cutting adjustment (See Fig 4)

The base plate (8) can be adjusted 45° (left or right) in relation to the saw direction to facilitate
contour sawing. Loosen the two screws under the base plate by using an inner hexagon
wrench (A), adjust the plate to the desired angle and retighten the screws (B)
Angle setting can be seen on scale on top of the base plate.

8.5

Switch on and off (See Fig. 5)

 Connect the battery pack (5) to the cordless jig saw and ensure it firmly.
 To switch on the jig saw, push the lock button (1) to left or right as the arrows shown and

press the ON/OFF switch trigger (2)

 When you release the switch trigger (2), the tool turns off.

8.6

Cutting-Orbital or Straight (Pendulum switch)(7)

This jig saw is equipped with four cutting actions, one straight and three orbital. Orbital action
has a more aggressive blade motion and is designed for cutting in soft materials like wood or
plastic. Orbital action provides faster cut, but with a rougher cut across the material. In orbital
action, the blade moves forward during the cutting stroke in addition to the up and down
motion.

Note: Metal or hardwoods should never be cut in orbital action. To adjust
the cutting action, moves the orbital switch knob between the four cutting
positions: 0, I, II, and III. Position 0 is the straight cutting. Positions I, II and
III are orbital cutting. The aggressiveness of the cut increase as the knob is
moved from one to three, with three being the most aggressive cut.