Powerplus POWX0075LI JIGSAW 18V LI-ION ONE FITS ALL EN - Manual (Page 7)

POWX0075LI EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
 Do not probe the charger.
 The charger is intended for indoor use only.
8 OPERATION
8.1 Charging the battery pack
The battery pack for this tool is supplied in a low charge condition to prevent possible
problems, therefore, you have to charge the battery before first use.
Note: Batteries will not reach full charge the first time they are charged.
Allow several cycles for the item to fully charge. The battery should only be
charged indoors.
After normal use, about 1 hour of charging time is required for the battery to be fully charged.
The battery pack will become slightly warm while charging, this is normal and does not
indicate a problem.
Do not place the charger in an area of extreme heat or cold. Best is at normal room
temperature. When the battery becomes fully charged, unplug your charger from the power
supply and remove the battery pack from the charger.
Note:
1.
Allow the battery pack to cool completely before charging
2. Inspect the battery pack before charging, do not charge a cracked or leaking battery
pack.
8.1.1 Charging indication (Fig 1)
The charger has 2 LED lights (red and green).
 Plug the charger into 230V-50Hz outlet. Do not use an extension cord. The green light will
light to show the power is connected.
 Slide the battery pack in the charger as shown in fig. 1. Make sure there is proper contact
with the charger.
 When charging the green is constantly lit and the red is flashing.
 When fully charged both lights will be constantly lit.
Note:If the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
3. Frequently monitor the charger and battery pack while connected.
4. For a fully discharged battery or a new battery, allow the battery pack to charge for 1
hour. The red and green lights will stay on (not flash) when the battery is finished
charging.
5. Unplug the charger and disconnect it from the battery pack when finished.
6. Allow the battery pack to cool completely before using it.
7. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.