Powerplus POWX0030LI SCREWDRIVER 3,6V LI-ION + LED LIGHT EN - Manual (Page 4)

POWX0030LI
EN
Copyright © 2014 VARO P a g e | 4 www.varo.com
5.4 Power tool use and care

Do not expect the power tool to do more than it can. Use the correct power tool for what
you want to do. A power tool will achieve better results and be safer if used in the context
for which it was designed.
 Do not use the power tool if the switch cannot turn it on and off. A power tool with a
broken switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store power tools, when not in use, out of the reach of children and do not allow people
who are not familiar with the power tool or these instructions to operate it. Power tools are
potentially dangerous in the hands of untrained users.

Maintain power tools. Check for misalignment or jammed moving parts, breakages or any
other feature that might affect the operation of the power tool. If it is damaged, the power
tool must be repaired. Many accidents are caused by using poorly maintained power
tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to jam and are easier to control.
 Use the power tool, accessories and cutting tools, etc., in accordance with these
instructions and in the manner intended for the particular type of power tool, taking into
account the working conditions and the work which needs to be done. Using a power tool
in ways for which it was not intended can lead to potentially hazardous situations.
5.5 Service
 Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
6 MACHINE-SPECIFIC SAFETY WARNINGS
 Hold power tool by insulated gripping surfaces, when performing an operation where the
fastener may contact hidden wiring. Fasteners contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the operator an electric shock.
 Protect the battery charger from rain and moisture. The penetration of water in a battery
charger increases the risk of electric shock.
 Recharge only with the charger specified by the manufacturer. A charger that is suitable
for one type of battery, it may create a risk of fire when used with another battery.
 Do not charge other batteries. The battery charger is suitable only for charging our lithium
ion batteries within the listed voltage range. Otherwise there is danger of fire and
explosion.
 Keep the battery charger clean. Contamination may cause the danger of electric shock.
 Check the battery charger, cable and plug each time before using. Do not use the battery
charger when defects are detected. Do not open the battery charger yourself and have it
repaired only by qualified personnel using original spare parts. Damaged battery chargers,
cables and plugs increase the risk of electric shock.
 Do not operate the battery charger on easily inflammable surfaces (e. g. paper, textiles,
etc.) or in combustible environments. There is danger of fire due to the heating of the
battery charger during charging.
 Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause irritation or burns.
 Do not open the battery yourself. There is danger of a short circuit.
 Protect the battery against heat, e.g., including against continuous sun irradiation and fire.
There is a danger of explosion.
 Do not short-circuit the battery. There is a danger of explosion.