Powerplus POW751 PAINT SPRAY GUN 100W EN - Manual (Page 10)

POW751 EN
Copyright © 2012 VARO P a g e | 10 www.varo.com
11.3 Over painting.
 Spray gun not clean. or not lubricated, resulting in piston being stuck in cylinder
Disassemble spray gun and clean with thinner.
 Too much paint
Adjust the volume clockwise to reduce spraying. Two thin coats are better then one thick coat.
 Viscosity too low
Check viscosity
11.4 Motor louder than normal
 Spray gun not clean. or not lubricated, resulting in piston being stuck in cylinder
Disassemble spray gun and clean with thinner.
11.5 No spray no sound.
 No electricity
Check power supply.
11.6 Operating sound not right.
 Poor output adjustment
Re-adjust
 Not enough paint in the container resulting in air being sucked in air being sucked in.
Refill with paint.
 Not diluting properly or not passing pick up pipe completely.
Check pick up pipe and viscosity level.
11.7 “Orange Skin " excessive fogging.
 Incorrect solvent is used
Use correct solvent
 Spray gun to far from the surface.
Hold spray gun closer to the object
 Paint too thick
Thin the pain
12 WARRANTY
 This product is warranted as provided by law for a 24 -month period effective from the
date of purchase by the first user.
 This warranty covers all material or production flaws excluding : batteries, chargers,
defective parts subject to normal wear & tear such as bearings, brushes, cables, and
plugs, or accessories such as drills, drill bits, saw blades, etc. ; damage or defects
resulting from maltreatment, accidents or alterations; nor the cost of transportation.
 Damage and/or defects resulting from inappropriate use also do not fall under the
warranty provisions.
 We also disclaim all liability for any bodily injury resulting from inappropriate use of the
tool.
 Repairs may only be carried out by an authorised customer service centre for Powerplus
tools.
 You can always obtain more information at the number 00 32 3 292 92 90.
 Any transportation costs shall always be borne by the customer, unless agreed otherwise
in writing.
 At the same time, no claim can be made on the warranty if the damage of the device is the
result of negligent maintenance or overload.