Powerplus POW703 HEAT GUN 1600W EN - Manual (Page 6)

POW703 EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
8.1 Mounting the correct accessory
This tool is supplied with a set of accessories for different applications
Icon Description Purpose
Glass protection nozzle Protecting windows when stripping frames
Spoon reflector nozzle Soldering pipes
Cone nozzle
Welding, shrink sleeving (heat concentrated over
small area)
Scraper Stripping paint and varnish
Make sure that the tool is switched off and the nozzle has cooled down.
Set the desired accessory onto the nozzle.
9 INSTRUCTIONS FOR USE
Always observe the safety instructions and applicable regulations.
 Use only one hand to hold the tool Do not place your other hand over the air vents
Prior to operation:
 Mount the correct accessory for the application.
 Set the desired air temperature.
9.1 Switching on and off
 To switch the tool on, set the on/off switch to position I. Some smoke may be emitted after
switching on; this does not indicate a problem.
 To switch the tool off, set the on/off switch to position O. Let the tool cool down before
moving or storing it.
9.2 Temperature setting.
Turn ON/OFF switch to 1 or 2, depending on temperature you need.. The heat gun will start to
buzz.
9.3 Stripping paint
 Mount an appropriate accessory.
 Set a high air temperature.
 Switch the tool on.
 Direct the hot air onto the paint to be removed.
 When the paint softens, scrape the paint away using a hand scraper.
Do not strip metal window frames, as the heat may be conducted onto the
glass and crack it. When stripping other window frames, use the glass
protection nozzle.