Powerplus POW6451 SHREDDER 2500W EN - Manual (Page 11)

POW6451
EN
Copyright © 2014 VARO P a g e | 11 www.varo.com
10 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
96 dB(A)
Acoustic power level LwA 111 dB(A)
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
aw (Vibration) 3,65 m/s² K = 1,5 m/s²
11 CLEANING AND MAINTENANCE
Before commencing cleaning and maintenance procedures, make sure the garden shredder is
switched off and disconnected from the mains supply. Always wear sturdy leather gloves when
cleaning the cutter blades.
 To ensure the best performance from the garden shredder, it must be kept clean.
 Always clean the garden shredder immediately after use.
 Do not allow material to become dry and hard on any of the garden shredder surfaces.
This will directly affect the shredding performance.
 Make sure that the inlet chute and the discharge chute are kept clean and clear of all
waste material.
 Make sure that all nuts, bolts and screws are tight and secure.
 Always have any damaged or worn parts repaired, or replaced by qualified personnel.
 Do not use detergents or solvents as these could cause irreparable damage to your
machine. Chemicals can destroy the plastic parts.
 Oil the drum every 4th or 5th (use BIO-degradable oil to protect environment).
11.1 Replacement of the cutters
If the cutters must be replaced, do it always in pairs. Open the shredder, block the cutter disc
with a screwdriver. Using the supplied hex wrench, screw out the socket head screws.
Assemble the new cutters in reverse order.