Powerplus POW63707T LAWNMOWER 1100W 330MM +TRIMMER EN - Manual (Page 12)

POW63707 EN
Copyright © 2010 VARO P a g e | 12 www.varo.com
13 SERVICE DEPARTMENT
Damaged switches must be replaced by our after-sales service department.
If the connecting cable (or mains plug) is damaged, it must be replaced by a special
connecting cable which is available from our service department. Replacement of the
connecting cable should only be carried out by our service department (see last page) or
by a qualified specialist (qualified electrician).
14 STORAGE
Always clean your mower before storage. Store your mower in a clean, dry environment.
To avoid mould on remaining contents, make sure the grass collect bag is empty and dry.
You can fold the handle to save space, loosen the 2 clamps on each side of the handle and
bend the upper handle part towards the front of the machine.
14.1 Long time storage:
Apply some environmentally friendly oil on the mower blade to prevent it from rusting.
14.2 Hibernation
Have your blade sharpened after the mowing season, so your machine is ready for the new
season.
15 TROUBLE SHOOTING
Problem Cause Action
Machine fails to operate Power turned off
Mains socket faulty
Extension cable
damaged
Fuse faulty/blown
Mower in long grass
Motor protector has
activated
Turn power on
Use another socket
Inspect cable, replace if
damaged
Replace fuse
Increase height of cut
and tilt mower
Allow to cool and
increase height of cut
Machine functions
intermittently Extension cable
damaged
Machine’s internal wiring
damaged
Motor protector has
activated
Inspect cable, replace if
damaged
Allow to cool and
increase height of cut
Machine leaves ragged
finish
Or motor labours Height of cut too low
Cutting blade blunt
Underside of machine
badly clogged
Blade fitted upside down
Increase height of cut
(see “Height of Cut
Adjustment”)
Replace blade (see
“Blade Maintenance”)
Clean machine (see
“After Mowing/Storage”)
Refit blade correctly
(see “Blade
Maintenance”)
Cutting blade not rotating
while machine switched on Cutting blade obstructed
Blade nut/bolt loose
Clear obstruction
Tighten blade nut/bolt
Excessive vibration/noise Blade nut/bolt loose
Cutting blade damaged
Tighten blade nut/bolt
Replace blade