Powerplus POW63703 LAWNMOWER 900W 320MM EN - Manual (Page 9)

POW63703 EN
Copyright © 2014 VARO P a g e | 9 www.varo.com
Check regularly that the blade is correctly secured, in good condition and well ground. If not,
grind or replace the blade. If the moving blade strikes an object, stop the mower and wait until
the blade has come to a complete standstill. Then check the condition of the blade and the
blade holder. If they are damaged, they must be replaced.
Place the mains lead in loops on the ground in front of the socket. Mow away from the socket
and cable and ensure that the mains lead is always on the section of lawn that you have
already mowed so that you do not run over the mains lead with the mower. As soon as you
see mown grass on the lawn whilst you are mowing, the grass bag will need emptying.
10 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull out the power
plug.
10.1 Cleaning
 Keep all safety devices, air vents and the motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow it with compressed air at low
pressure.
 We recommend that you clean the device immediately each time you have finished using
it.
 Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic parts of the equipment. Ensure that no
water can seep into the device.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10.2 Blade maintenance(fig.4)
 Regularly remove grass and dirt from the blade.
 At the beginning of the gardening season, carefully examine the condition of the blade.
 If the blade is very blunt, sharpen or replace the blade.
 If the blade is damaged or worn, fit a new blade.
Warning! Observe the following precautions:
 Disconnect the mower from the mains and wait until the blade has stopped rotating before
proceeding.
 Be careful not to cut yourself. Use heavy-duty gloves or a cloth to grip the blade.
 Only use the specified replacement blade.
 Do not remove the impeller (A)for any reason.
10.3 Replacing the blade
For safety reasons, we recommend having the blade replaced by an authorized professional.
Important: Wear work gloves!