Powerplus POW60476 BRUSH CUTTER 32.6CC EN - Manual (Page 6)

POW60476 EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
Warning: Make sure the grip is properly mounted and check it regularly.
Parts, which are not properly mounted, represent a risk of injury.
7.2 Mounting of the protective cover
 Attach the safety guard to the gear
case and fix it up with the clamp and
6 bolts securely.
 (1) Nut
 (2) Pipe
 (3) Clamp
 (4) Bolt
 (5) Junction panel
 (6) Safety guard
7.3 Cutting attachment mounting
 Set correctly the inner holder and the
outer holder to the gear shaft.
 Screw the attached bold into the gear
shaft and secure it with the spanner.
 Screw the nylon cutter into the bolt
by fixing the inner holder with the L-
shaped bar and tighten it manually.
7.4 Cutting blade mounting
Attention! During your work with the cutting device always wear work
gloves in order to avoid cutting injuries.
Attention! Use only metal cutting blades, which are not damaged or twisted.
 Set the inner holder to the gear shaft, and turn to
fix with the attached L-shaped bar.
 Put the blade on the inner holder with letters to the
gear case, and match correctly the hole of the
blade to the projection of the inner holder.
 Set the outer holder to the gear shaft with the
hollowed face to the blade.
 Put the attached bolt cover on the outer holder and
secure it with the bolt (left screw)together with the
spring washer and the washer.