Powerplus POW60476 BRUSH CUTTER 32.6CC EN - Manual (Page 5)

POW60476 EN
Copyright © 2014 VARO P a g e | 5 www.varo.com
 DO NOT TOUCH or let your hands or body come in contact with a hot silencer or sparking
plug wire.
 DO NOT OPERATE UNIT IN AWKWARD POSITIONS, off balance, with outstretched
arms, or with one hand. Always use two hands when operating unit, with thumbs and
fingers encircling the handles.
 DO NOT RAISE STRINGHEAD above ground level while unit is operating. Injury to
operator could result.
 DO NOT USE UNIT FOR ANY PURPOSES OTHER than trimming lawn or garden areas.
 DO NOT OPERATE UNIT FOR PROLONGED PERIODS. Rest periodically.
 DO NOT OPERATE UNIT WHILE UNDER THE INFLUENCE OF ALCOHOL OR DRUGS.
 DO NOT OPERATE UNIT UNLESS DEBRIS SHIELD AND/OR GUARD IS INSTALLED
AND IN GOOD CONDITION.
 DO NOT ADD, REMOVE OR ALTER ANY COMPONENTS OF THIS PRODUCT. Doing
so could cause personal injury and/or damage the unit, and void the manufacturer’s
warranty.
 DO NOT operate your unit near or around inflammable liquids or gases whether in or out
of doors. An explosion and/or fire may result.
 DO NOT USE ANY OTHER CUTTING ATTACHMENT. Only use our replacement parts
and accessories, which are designed specifically to enhance the performance and
maximize the safe operation of our products. Failure to do so may cause poor
performance and possible injury. Use only the stringhead supplied with this product. Do
not use any other cutting attachment. Use of such attachments will void your factory
warranty and may result in serious bodily injury.
6 PETROL SAFETY WARNINGS
WARNING: Use extra care when handling fuels. They are inflammable and
the vapours are potentially explosive. The following points must be
observed.
 Use only an approved container.
 Never remove the fuel cap or add fuel when the engine is running. Allow engine exhaust
components to cool before refuelling.
 Do not smoke.
 Never refuel the machine indoors.
 Never store the machine or fuel containers in places where there is a naked flame, such
as a water heater.
 If fuel is spilt, do not attempt to start the power source before moving the machine away
from the spillage area.
 Always replace and securely tighten the fuel cap after refuelling.
 Whenever the tank is drained, this should be done outdoors.
7 ASSEMBLY
7.1 Two-handed fork handle
 Loosen the handle screws and place the
handle into the holder, as depicted in the
main figure.
 Re-tighten the screws and verify they are
properly tightened.