Pow6016, 7 assembly – Powerplus POW6016 GRASS TRIMMER 500W 300MM EN User Manual
Page 5
POW6016
EN
Copyright © 2013 VARO
P a g e
| 5
www.varo.com
Do not use the appliance if the mains cable is damaged or worn.
Before use check the extension cord for possible wear and tear. In case of damage,
immediately remove the mains cable from the wall socket. Do not touch the cable before
the mains cable has been removed from the wall socket.
Do not use the appliance in the presence of children and/or animals.
Only use the appliance in daylight or with good lighting.
Never use the appliance without the guard in place.
Before using the appliance, remove sticks, stones, wire and other obstacles from the
surface on which you intend to work.
Only use the appliance in an upright position, with the cutting line pointing to the ground.
Never switch on the appliance in another position.
Always keep your hands and feet away from the cutting line.
Avoid touching the cutting line.
Make sure that the mains cable does not touch the cutting line.
Before putting the appliance down, switch it off and wait for the cutting line to come to a
complete standstill. Never attempt to bring the cutting line to a standstill yourself.
Beware. After switching off the appliance it continues to rotate for a short
time.
Only use the type of cutting line recommended by the manufacturer. Never use a metal
cutting line or fishing line.
Remove the plug from the wall socket when you have finished, before servicing, or when
the appliance is not being used.
After use, always store the appliance safely and out of the reach of children.
7 ASSEMBLY
The trimmer is supplied with some components which need to be assembled. Please
proceed as follows:
7.1
Safety guard assembly
Insert the safety guard (13) onto the motor
housing and secure it with the two screw.
Carfully peel off the tape overt he cutting
blade (16)
Warning: the guard has a very sharp cutting edge on 1 side for cutting the
nylon line.