Powerplus POW5623 AIR COMPRESSOR 12V EN - Manual (Page 5)

POW5623
EN
Copyright © 2013 VARO P a g e | 5 www.varo.com
 On no account should you point the air outlet towards any persons or animals.
7 ASSEMBLY
Depending which item you want to inflate, you need to use the correct adapter. You assemble
the adapter as follows:
 Loosen the knurled ring (1).
 Attach the flexible hose with connection in the knurled ring.
 Fasten the knurled ring.
 Connect an adapter on the flexible hose.
In some cases you do not need the pressure hose to create a tight connection between the
pump and the object. Then the adaptors may also be connected directly to the pump opening
and tightened with the coupling nut (1).
8 OPERATION
8.1 Charging the battery
With a 220V adapter (fig. C):
 Put the battery in the battery holder. Pay attention to + and - pole markings.
 Put the adapter plug of the net adapter in the connector on the side of the battery holder.
 Put the net adapter in the socket.
The red charging lamp on the battery holder will illuminate indicating the battery is being
charged.
The first charging process of a fully discharged battery will take approximately 5 hours the first
time and afterwards approximately 3 hours.
Remove the battery after the charging procedure from the charger. The
green light will go on, so keep an eye on the charging time!
8.1.1 With the car charger:
You can always recharge the battery by using the 12V car charger. This is only possible when
the motor of the car is running.
When the battery is fully charged, it is the best the air pressure pump is used until you notice
the tool receives less power.
When you recharge the battery when the battery still has power, the battery will loose a part of
its capacity.
When the battery gets fully discharged, you will also damage the battery, because of a polarity
switch.
When the tool will not be used for a longer time, please make sure the battery is fully charged.
8.2 Connecting and removing the battery(fig. B)
Insert the battery into the base of the appliance. Push the battery until it latches in.
Press the locking buttons on both sides before removing the battery, and disengage the
battery from the base of the appliance.
8.3 Switching ON/OFF
Switch the appliance on, by pressing the on/off trigger.
When you release the trigger, the appliance will be immediately switched off.
8.4 Inflating car tires
When you want to inflate a car tire, either place the air pump directly on the tyre valve, or by
using the pneumatic hose.