Powerplus POW2085 ANGLE GRINDER 710W 115MM EN - Manual (Page 7)

POW2085 EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
9 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9.2 Lubrication
The machine requires no additional lubrication
10 FAULTS
Should a fault occur e.g. wear of a part, please contact your local Power plus dealer.
11 TECHNICAL DATA
Voltage / frequency 230-240V / 50Hz
Power input 710W
No-load speed 12000/min
Disc diameter 115 mm
Spindle dimension M14
Weight 2.5 kg
12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
92 dB(A)
Acoustic power level LwA 103 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration): 25 m/s² K = 1.5 m/s²
13 SERVICE DEPARTMENT
 Damaged switches must be replaced by our after-sales service department.
 If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).
14 STORAGE
 Thoroughly clean the whole machine and its accessories.
 Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
 Protect it from exposure to direct sunlight. Keep it in the dark, if possible.