beautypg.com

Mounting a grinding disc (fig.2, Mounting the side handle (fig. 4), Operation – Powerplus POW2085 ANGLE GRINDER 710W 115MM EN User Manual

Page 6: Switching on and off

background image

POW2085

EN

Copyright © 2014 VARO

P a g e

| 6

www.varo.com

7.2

Mounting a grinding disc (Fig.2

– 3)

Use grinding discs of the correct dimension. Use fibre-reinforced grinding discs only. The
grinding disc must not touch the edge of the guard.
 Press the spindle lock and turn the spindle (2) until it engages in the lock. Keep the

spindle lock pressed during this procedure.

 Retrieve the outer flange nut (A) from the spindle using the spanner (9).
 Position the grinding disc (C)on the backing flange (B).
 Place the outer flange nut (A) on the spindle an tighten using the spanner (9).
 Release the spindle lock (2) and check that the spindle is unlocked by rotating it.

7.3

Mounting the side handle (Fig. 4)

The auxiliary handle can be attached to the angle grinder in two different mounting holes (10):
left and right.
The side handle can be used for both left-hand and right-hand control.
 Fasten the side handle for left-hand operation on the right-hand side of the machine.
 Fasten the side handle for right-hand operation on the left-hand side of the machine.
 Fasten the side handle for upright working at the top of the machine.

Make sure that the side handle is fastened propperly and cannot loosen
unexpectedly.

8 OPERATION

Do not place the machine on the work piece when switching the machine on or off. The
grinding disc may damage the work piece.
 Clamp the work piece and make sure that the work piece cannot slide from under the

machine during the cutting activities.

 Hold the machine firmly and press it under an angle of approximately 15' against the work

piece. Move the grinding disc evenly across the work piece.

 Regularly inspect the grinding disc. Worn grinding discs have a negative effect on the

efficiency of the machine. Replace a grinding disc on time.

 Always switch off the machine first before removing the plug from the wall socket.

8.1

Switching on and off

 You need to first press the switch button at its rear end and then push it forward to start

the tool

 To switch off, depress the on/off switch, this will then jump to the

‘off’ position.

WARNING

 Do not put the machine down when the motor is still running.
 Do not place the machine on a dusty surface. Dust particles may enter the mechanism.
 Never use the spindle lock to stop the motor.
 Never use the machine for grinding magnesium work pieces.