Powerplus POWXQ5243 DRILL/SCREWDRIVER 12V LI-ION 2 BATT EN - Manual (Page 8)

POWXQ5243 EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
Push the battery pack to make sure the contacts on the battery
pack engage properly in the charger.
When properly connected, the green and red light is lit
continuously, this means the battery is charging.
When the battery is fully loaded, the green light is continuously
lit and the red light is out.
If the green and red light flash alternating, .a malfunction
occurs.
8.3 To install or remove the battery pack
8.3.1 To remove the battery
Press the unlocking buttons and pull the battery out of the
machine to the rear. Do not exert any force.
8.3.2 to install the battery
Press the unlocking buttons and put the battery into the rear of
the machine. Make sure the battery latches into place.
8.4 On/off switch (5)
 To turn your drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.
8.4.1 Variable speed (3)
 Your cordless drill has a variable speed switch. The rotational speed and torque will in-/
decrease equivalently to applied trigger pressure. This drill has an electric brake, when the
trigger switch is released, the chuck stops turning.
8.4.2 Forward/reverse (right/left) (4)
The rotation of your cordless drill can be reversed. The direction of rotation is controlled by the
selector located above the trigger switch.
 F(Forward) (Forward): Press selector on right side of machine (to the left side): drill turns
right (forward, fasten screws)
 R(Reverse) (Reverse): Press selector on left side of machine (to the right side): drill turns
left (reverse/ loosen screws)