Powerplus POWXQ5205 IMPACT DRILL 1200W EN - Manual (Page 6)

POWXQ5205 EN
Copyright © 2015 VARO P a g e | 6 www.varo.com
 When using a cable drum uncoil the cable completely. Cross-section of wire at least 1,5
mm².
 Do not overload machine.
 Secure all work pieces to be processed sufficiently.
 Do not allow children to have access,
 Make sure you have a secure stand on ladders or scaffolding when using the drill
freehand.
 Localize lines with a line detector in walls where power, water or gas lines are laid
invisibly.
 Wear protection goggles and use a dust mask for dust-producing work.
 Always arrange for a qualified electrician to carry out repairs
 Use only original replacement parts.
Wear ear protectors when impact drilling. Exposure to noise can cause
hearing loss.
 The level of noise at the workplace may exceed 85 dB (A). In this case you will need to
introduce noise protection measures for the user. The noise generated by this electric tool
was measured in accordance with the relevant standards.
Use auxiliary handle! Loss of control can cause personal injury.
7 ASSEMBLY
Your POWXQ5205 comes fully assembled.
You only have to insert (when required) the depth gauge in the auxiliary handle.
To do so : loosen the handle by turning it anti-clockwise, insert the depth gauge (curved part
pointing to the front) as far as you want, then re-tighten the handle by turning it clockwise.
Note : take notice that the notch is located in the centre when you position the handle
lvertically.
8 OPERATION
8.1 Switching on/off (fig 1)
 To switch on: Press on/off switch (9)
 To switch off : release the on/off switch (9).
8.2 Continuous operation (fig 2)
 Switch the machine on, then lock the on/off switch by pressing locking button (8).
 To switch off: Press switch (9) briefly.
8.3 variable speed (fig 3)
 The speed is varied by applying more or less pressure on switch (9).
 You can pre-select the speed by turning the knurled screw (7) in switch (9).
 When required, you can decrease the setting of the maximum speed by turning the speed
control (7) anti-clockwise, when the machine is not running. This way the on/off switch (9)
, can not be pressed fully offering a lower speed. Let the machine run at no load to check
if the selected speed is suitable.
8.4 Gear selector switch. (fig 4)
(1).Position for 1st gear.
(2).Position for 2nd gear.